Evoluzione Series
Design gas fired unit heater with low NOx emissions
Evoluzione Type heaters have a wealth of controls to simplify and speed up installation operations and to tailor the installation to the requirements of the spaces to be heated.
Basic control - The simplest of the command options for Evoluzione Series.It allows summer/winter operation and manual switching of the heater between "maximum" and "economy” modes, it gives a warning if the operation of the appliance is blocked, and allows it to be reset. It is not possible to use the function of automatic modulation.
Room thermostat - Of the electromechanical type with ON-OFF switch, necessary for the control of heater operation when the basic command is used.
Thermostated control with temperature sensor - The thermostat performs all of the functions of the integrated command with the exception of timer programming. The temperature sensor, supplied with the command, can also be installed remotely (at a distance of up to 100 metres).
Integrated control and IP55 sealed integrated command with temperature sensor - These commands allow operation and programming of the individual Evoluzione Series heaters to be controlled remotely. With them it is possible to program switch-on of the heater on a weekly or daily basis, control the temperature of the room, set a minimum temperature (freeze protection), switch from summer to winter operation, and reset the appliance if required. The temperature sensor, supplied with the command, can also be installed remotely (at a distance of up to 100 metres).
Expansion module - Used with the thermostated command or integrated command, with the expansion module it is possible to control up to 3 heaters simultaneously. In addition, several expansion modules can be connected to each other to manage up to 150 heaters.
Share