PRO System Line RTYF Series
The unit consists of a gas absorption chiller and a condensing boiler.
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
(1) Operating point under nominal conditions according to EN12309-2. |
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Due to continuous product innovation and development, Robur reserves the right to change product specifications without prior notice. |
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Accessories
- Can bus cable connection for the connection between the direct digital control and the Robur units.
- Mosè hydraulic separator to balance hydraulic circuits, complete with automatic air discharge valve, water discharge valve and insulation.
- Air separator and sludge remover filters to care for the system and protect it from downtime and/or malfunctions due to the presence of excess of air or dirt.
- Flow regulator valve to allow the correct hydraulic balance, adjusting the flow rate during heating and cooling and therefore the optimal distribution of heating and cooling energy.
- Zone valves complete with actuator to be used to complete the secondary circuit.
- Anti-vibration support kit consisting of a series of elastic rubber feet to install under the unit base.
- Thermal flywheel for hot water storage, external painted, uncoated on the inside complete with soft polyurethane insulation.
- Flue gas accessories - Components required to build different types of flue gas discharges, made of translucent polypropylene for condensing units.
- Condensation pump to be connected to the water condensation discharge.
Share